Scissors or knife for cutting the power cable Optional: The power supply that we are using is manufactured by the company that makes the LED strips we're using and is designed specifically for the strips we are using. As you can see in this picture it is a 12V 18W supply with a 3 wire input. Those three wires are the standard AC power connections you find in most homes at least in the U. Those lines are ground, live or hot , and neutral. It then has a standard 2 wire 12V DC output on the other side.
How to Install Offroad Lights on Your Vehicle | YourMechanic Advice
Silicone Touchup paint Step 1: Determine your mounting location. Your offroad lights will need to be mounted in a location where wiring can be run in a relatively safe fashion. The fasteners on the lights will need to be accessible to tighten them sufficiently. The area will need to be flat if it is roof-mounted so you can seal the spot after the light is mounted. Mark the light locations. Put a piece of masking tape on your mounting location for one side and mark the exact spot clearly with a marker or pen.
Wiring your LED Strip to car audio amp | Oznium Blog
They come in 12 volts and 24 volts. You want 12 volts if your car has a volt battery most do. The roll contains lights, and they are typically available in white, red, yellow, green, blue and multicolored. White and yellow were too bright for my purpose, so I went with a cool blue to provide subtle ambient light.
Fuse Holder optional Step 1: Open up the cover that way in the back behind the gas and break pedals. Use the wire clothes hanger take it apart and wrap the LED strip electric wires around it so it can push the wire up thought the hole and reach it near the battery. Make sure to leave enough slack on the other end in order to have enough room to work with.